matrix v3 to 192 MHz??

I have tried to compile my code base x360ace for Matrix and I installed o_O (no middle fewer resources on the chip XC2C64A)

as you (should?) You know, the point RST alternative is more reliable because it requires less time to set the RST line to zero. But in the case of Matrix, CR3 Lite and other GliGli-project based FPGAs, which have only 48 MHz oscillator, which is too difficult for you (you need at least ~ 150 MHz). You can easily get 96 MHz internal Xilinx features, but that is still not enough.

But after I used my soft "trick" to double the clock ...

Well, we now have 192 MHz to 48 MHz source, yay!

This file works on my Jasper with Matrix. Not as impressive as x360ace, but still, it works!

Welding is the same as always, but CPU_RST ('A') is the alternative [/ b]

FILE
https://dl.dropboxusercontent.com/u/16255396/hackfaq_soft/ma_l1n8.xsvf

cpu-rst alternative (A)



excellent contribution

richy could create firmware for CORONA,TRINITY,FALCON??

thx

 

Great. What about trinity, corona RST?

 

if great news

Needless to support Corona and trinity, this would be excellent

 

startups have been between 5 and 10 seconds

 

Thanks richy by timming

MATRIXV3 is a legendary chip, with these timmin will be powerful and handy

making test in tinity



You can support us CORONA please

 

Ричи, а под джасперы?

 

Обязательно отключите все конденсаторы между RST и GND.

это значит просто не ставить перемычки?

 

hello richy
i
n slim should be left open pads ??
phat and we can close them ??


well in a closed phat pad

 

RichY круто!
Как насчёт скомпилировать тоже под Squirt 1.0 ?

 

Он и не нужен!

 

А если залить такую прошивку в Squirt bga то будет то что надо!