I have tried to compile my code base x360ace for Matrix and I installed o_O (no middle fewer resources on the chip XC2C64A) as you (should?) You know, the point RST alternative is more reliable because it requires less time to set the RST line to zero. But in the case of Matrix, CR3 Lite and other GliGli-project based FPGAs, which have only 48 MHz oscillator, which is too difficult for you (you need at least ~ 150 MHz). You can easily get 96 MHz internal Xilinx features, but that is still not enough. But after I used my soft "trick" to double the clock ... Well, we now have 192 MHz to 48 MHz source, yay! This file works on my Jasper with Matrix. Not as impressive as x360ace, but still, it works! Welding is the same as always, but CPU_RST ('A') is the alternative [/ b] FILE https://dl.dropboxusercontent.com/u/16255396/hackfaq_soft/ma_l1n8.xsvf cpu-rst alternative (A) excellent contribution richy could create firmware for CORONA,TRINITY,FALCON?? thx
окей, вот вам пока под Trinity: https://dl.dropboxusercontent.com/u/16255396/hackfaq_soft/TR_M_192.rar важно отрубить все конденсаторы между RST и GND (типа не замыкать нижнюю перемычку на матриксе) судя по результатам с x360ace, параметры должны подойти. лучшего на матриксе не добиться
Thanks richy by timming MATRIXV3 is a legendary chip, with these timmin will be powerful and handy making test in tinity You can support us CORONA please
Если на матрикса - то только верхнюю ставить. На кулранере в слим режиме придётся выпаивать кондер. На cr3lite просто выставить режим без кондеров
hello richy i n slim should be left open pads ?? phat and we can close them ?? well in a closed phat pad
matrix - upper pad = slim, lower pad = not set cr3 lite - no cap (S2 = 1, 5 on) coolrunner C/D - slim, desolder cap between RST and GND